12v-12v battery charger, 12v-12v_battery_charger
Euro Manufacturing And Marketing
Electronic Products For The Automotive Market
E914 BATTERY CHARGER 12V - 12V @ 12A
This Unit was designed to charge Batteries.
A Low Power Control Wire has been included to Stop and Start the Charger, reducing the need for High Current On / Off Switches. This wire also senses the input voltage.
The Charger starts when the voltage reaches approximately 12V.
There is 0.1V of hysteresis to prevent spurious switching.
Wiring Diagram without
E916 Control Voltage Adjuster
The charger output current is limited to 12A.
Protection against reverse polarity connection is achieved using external fuses.
For some applications it may be necessary to vary the Control Switching Voltage of the Unit. Example: When charging Leisure Batteries from the Engine Battery and Alternator to prevent the Engine Battery from being discharged beyond the required level when the Alternator is not charging.
The E916 Control Voltage Adjuster is an add on module that allows the Installer to adjust the Voltage at which the Charger Switches On / Off. The Voltage can be set in the range 12.3V to 13.5V
Wiring Diagram
with
E916 Control
Voltage Adjuster
Note:
If the Input Voltage is more than 15V, the Output Voltage will rise above 14V and the battery could overcharge